A light cured, methacrylate based, unfilled, penetrating, low viscosity resin. The Sealant has a very low oxygen inhibition layer and can be cured in ultra thin layers. Reduces microleakage and seals micro-cracks and irregularities in composite restorations. Finishing and polishing composite creates microscopic defects in the surface and at the margin, resulting in accelerated loss of composite. Prime-DentŪ Light Cure Composite Surface Sealant is applied immediately upon completion of restoration. The Sealant penetrates and seals the composite surface, thus reducing wear and marginal breakdown. Microleakage is reduced for new and existing composite restorations. Bonds well to composite type provisional restorations and helps re-vitalize old composites leaving a smooth enamel like finish.

005-010 VLC Composite Surface Sealant 7 ml Bottle

A 5th generation, single component, multi-use adhesive, which is hydrophilic and suitable for use on moist dentin (wet bonding technique). The adhesive incorporates aspects of primer and bonding resin in a single bottle designed to bond composites and compomers to dentin and enamel as well as treated amalgam, metal and ceramic surfaces. After etching, penetration and saturation of the dentin and enamel are accomplished in 2 to 3 coats. 

006-030 VLC One Step Dentin/Enamel Bonding Adhesive 7ml bottle (Acetone Eased)

A Bis GMA based adhesive to be used with chemical cure composites, core materials and luting cements. Has a high bond strength to both enamel and dentin. 

006-021 Chemical Cure Dentin/Enamel Bonding (2-3ml bond, 7.5 ml etch)

An economical Bis GMA based adhesive that bonds to dentin, enamel, treated porcelain, amalgam and composites. Easy to use and has a long shelf life.